AMF S-100 Service Manual download pdf (Page 10)

S-101

e-mail: [email protected]; [email protected]; website: www.amfreece.com

Phones: +420 582 309 146+ (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606

Revised 09/2004

1-4

Before operating the machine by hand or power, remove the two shipping pins n shown Fig.1, which

are easily identified by a red tag tied to each - these pins n are installed at the factory to lock the

Head o and Bed Plate p together as a protection against shipping damages.

Set up machine in accordance with the instructions on the installation template that is sent with

each new machine. This template shows two different installations depending on direction of

rotation of the power shaft. The one marked „Preferred Installation“ on which the left hand

machine belt is crossed and the

right hand one open, should

always be employed when the

machine is installed on a Reece

Individual Motorized Table. The

„Preferred Installation“ should also

be used whenever possible in cases

where the machine is installed on a

line shaft table.

In the event that the machine

should be disassembled at any

time, the correct line-up of the

Head o on the Bed Plate p can be

re-established by using one of the

shipping pins n in the follower

manner:

Turn the left hand crank handle until

shipping pin hole q Fig. 2 in the

Head o corresponds with shipping

pin hole r in Bed Plate p. If holes

q and r do not line up exactly,

loosen clamp screw u Fig. 2 and

move the Head o of machine to left

or right until holes q and r line up

when tested with the shipping pin.

If no shipping pin is available,

proceed as outlined above, but match

line s on Head o with line t on

Bed Plate p as illustrated Fig. 2.

Important - Before tightening clamp

screw u, press lever 1-C19 v

upward on the stud to lightly contact

the shoulder of the Cam Case w.

Note - Do not follow these line-up

instructions on Adjustable Fly Bar

machines. Use the instructions on

Sheet 28.

MODEL 101 - SETTING UP INSTRUCTIONS

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 53 54

Comments to this Manuals

No comments

AMF S-100 Service Manual Page 10

Comments to this Manuals

Related products and manuals for Sewing machines AMF S-100