AMF S-100 Service Manual download pdf (Page 40)

1-34

S100

Revised 10/2005

e-mail: [email protected] ; [email protected]; website: www.amfreece.com

Phones: +420 582 309 146 (Service), +420 582 309 286 (Spare Parts); Fax: +420 582 360 606

D - MACHINE ADJUSTMENT

8. BED PLATE ALIGNMENT

Make the adjustment with the lateral cam for sewing of the buttonhole without eye and without flybar.

1. Remove feet plates and instead of stitching plate install support of the gauge  from accessories.

2. Turn by the handle and stop the machine approximately in the middle of the table protrusion

.

Measured distance between support of the gauge  and the table slat  on the right side has to be

the same as distance between support of the gauge and table slat on the left side after moving to the

same place after race turning.

3. Possible difference adjust after loosing the nut stud  of the cam  by its shifting to reach identical

distance x

= x

. Tighten the nut well.

9. SETTING OF THE CAM POSITION

In home position of the machine, during cutting after, adjust the position of the cam holder, so that locating

pin points obliquely towards operators.

Loosen adjusting screws on the shaft in teething of the cam and turn with the cam. By this will be change the

buttonhole eye shape. Tighten adjusting screws.

Remove cutting knife and take the thread out of the machine. Insert the paper under clamp feet and without

thread sew the buttonhole on the paper for check. If the eye shape looks like picture 1 below, turn the cam

in direction 2. If the eye shape looks like picture 2 down, turn the cam in direction 1.

CAUTION! To perform correct adjustment, turn with the cam very softy.

Cam holder











1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 93 94

No comments

AMF S-100 Service Manual Page 40