Released: 10/2013
Phone: +420 582 309 146; Fax: +420 582 360 606
C - CORRECT USAGE
2. NEEDLE EXCHANGE
2.1. Loosen the securing screw of the needle
and remove the original needle.
2.2. Place the needle so that the grove A of the needle is on the other side than the tensor
. The needle must not
have broken tip or other defect. You can check whether it is straight, if you roll the needle on the at pad. A good
needle does not deect in the tip.
2.3. Tighten the screw
.
3. THREADING THE MACHINE
WARNING!
make sure the power is switched off!
Look and quality of the buttonhole is inuenced by:
- threads, their elasticity and resistance to breakage
- thread thickness – make sure that thread has the same thickness
- material sewn (thickness, density, ber direction)
- upper and lower thread tension
- stitch density - see section A5
- stitch width
- technology of sewing process (size of material spreading, distance of stitches from the cut edge)
Correct buttonhole should have:
- uniform stitch density
- consistent chain formation
- symmetric eye shape
- proportional shape and size
- smoothly trimmed threads
S-101.M
1-17
Comments to this Manuals